33
Answering System Operation
FEATURE SUMMARY
Default settings indicated by * .
Answering System Operation
When you turn Announce Only ON, callers hear
your announcement, but cannot leave a message.
FEATURE SUMMARY
Default settings indicated by * .
SYSTEM ANNOUNCES:
DESCRIPTION/DIRECTIONS:
“Set Security Code”
50*
Set the remote access code you will use to ac-
cess features and functions of the answering
system from a touch tone phone. The code can be
changed to any two-digit number from 40 - 99.
“Set Audible Message
Alert”
Off*/On
When Message Alert is turned ON, the base beeps
once every 10 seconds when new messages have
been received.
“Set Announce Only”
Off*/On
“Set Base Ringer”
Off/On*
Turn the Base ringer on or off.
Choose how many times the phone will ring before the
system answers a call. With Toll Saver active, the
system answers after two rings when you have new
messages and after four rings when you have no new
messages.
“Set Number of Rings”
2
4*
6
Toll Saver
NOTE:
You can press and hold
CHANGE
to advance the remote access code
in increments of ten.
NOTE:
Exit Feature Setup at any time by pressing a
PLAY/STOP
button.
Listen to, Save & Delete Messages
The system automatically saves your messages until you delete them and can store 15
minutes of messages, memos, and announcements (up to a maximum of 99 messages).
A message or memo can be up to 4 minutes in length.
Before playing a message, the system announces the day and time it was received. While
the message plays, the message window displays the number of the message. After play-
ing the last message in a mailbox, the system announces “
End of messages
.” If the
system has less than five minutes of recording time left, it announces the remaining time.
