4
Wrist Strap Fastener
If you wish, attach a wrist strap here. (NOTE:
Wrist strap not included.)
Slide this switch to open the battery door.
Always replace the
InnoTab
®
2
battery door
after changing batteries.
SD Card Slot
Insert an SD memory card (not included).
(NOTE:
InnoTab
®
2
is compatible with SD and
SDHC memory cards up to 32GB.)
Battery Compartment
Insert 4 AA batteries (not included). For
battery installation instructions, please see
the next section.
Stand
Pull out this stand to prop up
InnoTab
®
2
and
use it as a digital photo frame.
Battery Installation
• Make sure the tablet is turned off.
• Locate the battery door lock sliding switch on the
back of the tablet. Slide the switch to open the
battery door, then remove the door.
• Insert 4 AA batteries as shown in image 2.
• Make sure to replace the battery cover.
Battery Notice
• Use only batteries of the same or equivalent type
as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-zinc)
or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
2
1
GE
TTiNG ST
arTEd
Battery Door Lock Sliding
Switch
