33
33
33
6. Mount the holder or waterproof case on the bike mount. Align the
tripod screw hole on the camera holder or waterproof case to the
screw of the bike mount. Screw the knob on the bike mount clockwise
to connect the camera to the mount.
7. The camera is attached on the bike and ready for use. Loosen the
angle adjustment handle and you can rotate the angle adjustment
arm to adjust the capture angle.
8. Tighten the angle adjustment handle after you have set the capture
angle.
Caution:
Do not adjust the mount while riding.
Using the Adhesive Mount
1. Attach the adhesive flat mount to the
mounting attachment as illustrated. You will
hear a click when the attachment is seated
correctly.
2. Ensure the surface to which you would like to
affix the adhesive mount is clean and smooth.
Note
: If there is dirt or liquid on the surface or the surface is rough,
the adhesive performance will be negatively affected.
3. Remove the protective cover of the adhesive and stick it on a clean,
flat and smooth surface.
Note
: If the surface is not very flat or a bit curved, such as that of
a helmet, add the extra two double-sided adhesive tape strips
(included) onto the adhesive flat mount to improve the contact area
between the surface and the adhesive flat mount.
Remove the protective covers of the adhesive flat mount and the
extra double-sided adhesive tape strips. Stick the two tape strips
onto both tips of the adhesive surface of the adhesive flat mount.
Next, affix the adhesive flat mount to the surface you have chosen.
4. Apply firm pressure to the adhesive flat mount and the contact
surface and ensure that the surface makes contact over the entire
area.
