9
CONNECTING TO A COMPUTER
You can connect
Kidizoom
®
Camera Pix
TM
to a PC or Mac computer
by using the micro usB cable (not included). once connected, you can
transfer files between the camera and computer. Please follow the below
steps to make the connection.
• Turn the camera
OFF
before connecting to a computer.
• Pull up the rubber cover of the USB port at the bottom of your camera.
• Insert the small end of the USB cable (not included) into the USB port
on the camera.
• Insert the larger end of the USB cable (not included) into a USB port on
the computer. a usB port is usually marked with this symbol
.
• Two removable drives called “
Vtech 1936
” and “
Vt sYstem
” will
appear. “
Vtech 1936
” is for storage of your data, “
Vt sYstem
” is for
storage of system data and cannot be accessed.
Note:
If there is a memory card in the camera, the removable drive will
show the content in the memory card only.
to avoid any potential damage to your Kidizoom
®
Camera Pix
TM
•
when the usB cable (not included) is not connected to the unit, en-
sure the usB rubber cover is fully covering the usB port of the cam-
era.
•
Please ensure the microsd card slot rubber cover of the camera is
fitted in place.
NOte:
once the camera is connected to your computer, do not insert or remove
the memory card and do not disconnect the camera while files are
uploading or downloading. After you have finished, remove the camera
by following the steps to safely remove hardware from your computer.
You can then physically unplug the camera from the computer.
To back up photo or video files taken by the camera:
• Locate and open the “
DCIm
” folder in the removable drive “
Vtech 1936
”.
C
O
N
N
E
C
TI
N
G
T
O
A
C
O
M
PUTE
R
