WEARING THE SMART WATCH
People with very sensitive skin may notice some irritation after wearing
the
Kidizoom
®
Smart Watch DX2
for extended periods of time. Skin
may become irritated when moisture, sweat, soap, or other irritants get
trapped under the wristband. To prevent this, we suggest that children
remove the watch before going to bed for the night, to take the watch
off if it's feeling uncomfortable, and keep their wrist and the band clean
and dry.
In addition, wearing the watch too tightly may also cause irritation.
Make sure the fit is good - tight enough so the watch stays in place, but
not so tight that it's uncomfortable. If you notice any redness, swelling,
or other irritation, you may want to consult a doctor before wearing the
watch again.
GETTING STARTED
Master Power Switch
When using the
Kidizoom
®
Smart Watch DX2
for the first time, you will need to slide the
Master
Power Switch
(located on the underside of the
watch) to the
ON
position
. You may need a
small tool such as a paper clip to move the switch
to the ON position. It is recommended to fully
charge the watch before first use. A full charge will
take approximately 3 hours.
When the
Master Power Switch
is set to the
OFF
position, the unit
will not function and the battery will not charge. Only move the switch
to the
OFF
position when the watch will not be used for an extended
period of time.
Note:
It is not necessary to switch off the watch in daily use. Once the
Master Power Switch
is set to the
OFF
position, the watch will stop
functioning. After the watch has been turned on again, the time and
date has to be reset.
BATTERY RECHARGING
Note
: Adult operation required.
To charge the
Kidizoom
®
Smart Watch DX2
, the watch needs to be
connected to a computer with the included
Micro-USB Cable
. To do
so correctly, please follow these steps:
• Make sure that the
Master Power Switch
is set to the
ON
position
before charging.
• Pull up the rubber cover of the
Micro-USB Port
on the side of the
watch.
6
