8
PRODUCT FEATURES
1. TURN THE UNIT ON
Slide the
Remote Control Off/Channel Switch to the
I or II position to turn the Remote Control ON.
Slide the
Off/Channel Switch on Bronco the
Triceratops to the same I or II position as the Remote
Control. The Remote Control and Bronco the
Triceratops must be on the same I or II channel to
send and receive signals.
Note: I and II settings are two different channels the Remote Control
and
Bronco the Triceratops can operate on. If two units are
operating in the same vicinity, put one unit on channel
I and
the other on channel
II.
2. REMOTE CONTROL POWER INDICATOR
After the
Remote Control is turned ON, the
Remote Control Power Indicator
will flash to
show the remote is
ON. The indicator light will
illuminate anytime a button is pressed, lever is
pulled or the
Steering Wheel is turned. The light
indicates a signal is being sent to
Bronco the
Triceratops.
3. SWITCH BUTTON
Press the
Switch Button to remotely switch
Bronco the Triceratops from dino to vehicle or
from vehicle to dino.
P
ro
du
ct
F
ea
tur
es
