5
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned
OFF
.
2. Locate the battery cover on the bottom of the
Go! Go! Smart Wheels
TM
Traffic Signal
Bridge
. Use a coin or a screwdriver to loosen
the screw.
3. Install 2 new ‘AA’ (LR6/AM-3) batteries
following the diagram inside the battery
box. (The use of new alkaline batteries is
recommended for maximum performance.)
4. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as
recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
Getting St
ar
ted
