42
*
and
SENSOR
light on the telephone base will not be displayed when motion sensor is triggered.
Test sensor signal strength
Before you mount the sensor, follow the instructions below to check the signal
strength between the sensor and the telephone base. Make sure you mount the
sensor in a location where the signal strength is good.
Using a handset:
Press
MENU
on the handset when idle.
Press or
on the handset, or
CALLER ID /
or
PHONEBOOK/
on the telephone base to scroll to
Sensor setup
, and then press
SELECT
.
Press or
on the handset, or
CALLER ID /
or
PHONEBOOK/
on the telephone base to scroll to
Check signal
, and then press
SELECT
.
Press or
on the handset, or
CALLER ID /
or
PHONEBOOK/
on the telephone base to scroll to the sensor you want to test,
and then press
SELECT
.
The screen displays
Test signal strength between base and sensor
. Press
NEXT
.
The screen displays
Please trigger your sensor now.
. Trigger your sensor
(refer to
Installation Guide
), and then press
NEXT
. The screen displays
Awaiting signal... Please wait
.
If the screen displays
No signal. Please try again.
. Press
OK
, and then
return to step 3 to test again.
If the screen displays
Weak signal Move sensor closer to base.
, adjust the
sensor’s location to improve the signal, and then press
NEXT
.
7. When the screen displays
Good signal. Good location for sensor.
. Press
OK
.
1.
2.
3.
4.
5.
6.
•
•
Set schedule
Open/closed 1
