VTech VSP505, User Manual

27

Appendix

FCC, ACTA and IC regulations

FCC Part 15

This equipment has been tested and found to comply with the requirements for a Class B digital device under 

Part 15 of the Federal Communications Commission (FCC) rules. These requirements are intended to provide 

reasonable protection against harmful interference in a residential installation. This equipment generates, uses 

and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 

cause harmful interference to radio communications. However, there is no guarantee that interference will 

not occur in a particular installation. If this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and on, the user is encouraged to try to 

correct the interference by one or more of the following measures:
•  Reorient or relocate the receiving antenna.

•  Increase the separation between the equipment and receiver.

•  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• 

Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this equipment not expressly approved by the party responsible for compliance 

could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) 

this device may not cause harmful interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation. Privacy of communications may not be ensured 

when using this telephone.
To ensure safety of users, the FCC has established criteria for the amount of radio frequency energy that can 

be safely absorbed by a user or bystander according to the intended usage of the product. This product has 

been tested and found to comply with the FCC criteria. The headset may be safely held against the ear of the 

user. The telephone base shall be installed and used such that parts of the user’s body other than the hands 

are maintained at a distance of approximately 20 cm (8 inches) or more.

FCC Part 68 and ACTA

This equipment complies with Part 68 of the FCC rules and with technical requirements adopted by the 

Administrative Council for Terminal Attachments (ACTA). The label on the back or bottom of this equipment 

contains, among other things, a product identifier in the format US:AAAEQ##TXXXX. This identifier must be 

provided to your telephone service provider upon request.
The Ringer Equivalence Number (REN) is used to determine how many devices you may connect to your 

telephone line and still have them ring when you are called. The REN for this product is encoded as the 6th 

and 7th characters following the US: in the product identifier (e.g., if ## is 03, the REN is 0.3). In most, but not 

all areas, the sum of all RENs should be five (5.0) or less. For more information please contact your telephone 

service provider.
This equipment may not be used with Party Lines. If you have specially wired alarm dialing equipment 

connected to your telephone line, ensure the connection of this equipment does not disable your alarm 

equipment. If you have questions about what will disable alarm equipment, consult your telephone service 

provider or a qualified installer.