Getting started
4
Add and register a headset
Each newly purchased headset
(VSP505)
must be registered to a compatible VTech
VSP series SIP telephone before use.
The telephone base recognizes and counts a headset the same as a handset. You
can place the headset charger anywhere you have an available power outlet.
You can register one headset to one VTech SIP telephone. If the telephone already
has a headset registered, you need to follow the deregistration instructions on page 5
or in your telephone user’s manual before adding a new headset.
To register a headset:
1. Place the non-registered headset in the headset charger and allow it to charge for
at least 15 minutes before beginning registration.
2. On the telephone, press
MENU
and then select
User settings > DECT headset
.
3. Lift the cordless headset out of its charging base, and then place it back in the
charger. The
light on the headset flashes slowly and alternately in red and blue.
4. On the telephone’s
DECT headset
menu, select
1. Register
.
It takes about 60 seconds to complete the registration process. The
light on the
headset turns red when it is registered but not fully charged, or turns blue if it is
registered and fully charged.
If the registration process is successful, you hear a dial tone when you press on
the headset. If the registration fails, you hear “
Not registered
” when you press on
the headset. The
light on the headset flashes slowly and alternately in red and
blue. To reset the headset, remove it from the headset charger and then place it back
into its charger. Try the registration process again.
• You cannot register a headset if any other system handset or headset is in use.
You can only register one headset to the telephone base at a time.
• The headset must be deregistered before registering it to another telephone
system.
Summary of Contents for VSP505
Page 1: ...User s manual VSP505 DECT Cordless Headset ...
Page 35: ......
