25
24
MEMORY DIALING
Storing Memory (Speed) Dial
numbers
To program a speed dial location, do
the following:
•
With the phone OFF, enter the
telephone number you wish to
store. (20 Digits Maximum).
•
Enter program mode by pressing
PROG . The display will show the
following:
•
Enter the memory location
(01..20) you wish to store the
number in. As soon as the
second memory location digit is
entered, the unit will emit a happy
tone (a short series of beeps) to
confirm successful programming
and exit program mode.
STORING SPEED DIAL
NUMBERS
ENTER THE PHONE
NUMBER
PRESS
PRESS LOCATION
(01-20)
If programming is unsuccessful the
unit will display:
Unsuccessful programming can result
from not correctly completing the
programming sequence. For
example, if after entering a number on
the LCD and entering program mode,
the OFF key were pressed instead of
entering a valid memory location, the
"PROGRAMMING INCOMPLETE"
message would appear. If this
message appears, simply repeat the
programming sequence.
ADVANCED FUNCTIONS
Advanced Dialing
There are two different ways to dial
a number:
1. Press PHONE and wait for a dial
tone. Then dial the number you
want either manually, using
MEMORY (MEM) dialing, CID
dialing or REDIAL.
2. Enter the number you wish to dial
on the display first. Then press
PHONE . This will dial the number
which is displayed on the LCD
after 2 seconds.
NOTE:The phone will dial any number
which is shown on the display.
If you do not want to dial the
number shown on the LCD, it
can be changed by:
•
Press and hold CLR/DEL until
the display is cleared, then dial
normally.
•
Press OFF and start over.
or
