V
TECH
E
NGINEERING
C
ANADA
L
TD
.
TITLE
Product Specification
MODEL
VTH1930 (Wireless Headset Phone)
Reference: PRC 00B6
Revision: 0
Page: 5 of 31
This document is proprietary to V
TECH
E
NGINEERING
C
ANADA
L
TD
.
Specifications are preliminary and are subject to change without notice.
21146
•
Non-volatile storage of security code at base unit protects against power failure
•
In-the-dark answering of incoming calls
1.3.2
Unique Features
•
Headset Binaural Sound using two receivers (non HAC)
•
Headset will be re-chargeable via placement on remote charger.
•
Retractable antenna will be incorporated into headset design.
•
Volume up/down
keys available on headset module.
•
Flash
key will be available on headset module to switch between lines during a call
waiting condition.
•
A CR2025 battery with an estimated lifetime of 1.5 yrs will be provided with remote
dialcard and will be easily replaced via a sliding battery door.
•
The effective distance of the dialcard will be over 15 ft. in normal lighting conditions.
Under direct sunlight, the range will be limited to 4 ft (enough to allow hand held
dialing).
•
A plastic loop at the top of the dialcard chassis will allow for the attachment of an
accessory strap to allow the user to hang the unit around the neck, dangle off the
wrist, or dangle of a belt clip.
•
64 different combinations of dialcard security code will be randomized in the factory
to prevent interference between different remote dialcards.
•
Corded handset on base will have HI/MID/LOW volume control via slide switch on
handset.
•
Base dialing keypad is provided.
•
PPU will be provided for in SW as a future option.
•
The base will be equipped with VMWI as an available option. The base will be
equipped with a speaker to indicate ringing, paging & other base status.
•
The unit will include a ringer HI/LO/OFF on the side of the unit for volume
adjustment as well as programming of individual ringer types (base only).
•
A tone pulse switch will be accessible on the bottom of the unit.
•
POTS mode will be available on the base via the spare battery.
•
A trickle charging bay will be provided on the base unit (20-30 hours charge time).
•
Remote charger will fully charge headset battery within 2 hours.
•
Remote charger LED will glow red during fast charging, and will go green after the
charge is complete. There will be no Power LED indication for the remote charger
unit.
•
Headset will automatically turn OFF when placed in remote charging unit, regardless
of the mic boom position.
•
Remote charger will have its own 300mAH power adapter which is interchangeable
with the base unit power adapter so the end user will not be confused.
•
Headset will ring when in the remote charge and will auto-answer when lifted out of
the base cradle only if the mic boom is already in the ON position.
