www.vtiinstruments.com
VM2710A Command Dictionary
43
Command
Description
*RST
Reset Value
CONFigure:VOLTage:AC
Selects the ac-coupled rns voltage
function
X
Autoranging
1 PLC
CONFigure:VOLTage[:DC]
Selects the dc voltage function
X
Autoranging
1 PLC
FETCh?
Retrieves most recent measurements
stored by last INITiate command
N/A
FORMat
Sets the measurement data format
X
Exponential
format
FORMat:OVERflow
Sets the OVERflow function
X
NONE
INITiate[:IMMediate]
Places the multimeter in the wait-for-
trigger state
X
Idle state
INPut:SOURce
Selects input channel
X
Input A
MATH
Selects math function
X
0
MATH:FACTor
Sets the factor value
X
1
MATH:OFFSet
Sets the offset value
X
0
MEASure:CURRent:AC?
Selects the ac current function
X
Autoranging
1 PLC
MEASure:CURRent[:DC]?
Selects the dc current function
X
Autoranging
1 PLC
MEASure:FRESistance?
Selects 4-wire ohms function
X
Autoranging
1 PLC
MEASure:RESistance?
Selects the 2-wire ohms function
X
Autoranging
1 PLC
MEASure:VOLTage:AC?
Selects the ac-coupled rms voltage
function
X
Autoranging
1 PLC
MEASure:VOLTage[:DC]?
Selects the dc voltage function
X
Autoranging
1 PLC
MFGTEST 99
Enables or disables the ohms current
function
X
1
OUTPut:TTLTrg
Selects the a specified VXIbus trigger
line (0-7)
X
0
(lines 0 - 7 off)
OUTPut[:TTLTrg]:POLarity
Sets the output signal polarity
X
NEG
RANGe:AUTOmatic
Enables the autoranging function
X
1
RANGe:DELay
Sets the delay (settling) time after a
function and/or range change
X
Default Delay -
see command
RANGe:DELay:AUTOmatic
Uses the default delay times
X
1
READ?
Transfers the readings to the output
buffer
N/A
SAMPle:COUNt
Sets the number of readings per trigger
X
1
SAMPle:SOURce
Selects the pacing source for the sample
rate
X
IMM
SAMPle:TIMer
Sets the period between readings
X
0.0
[SENSe:]BANDwidth:DETector
Selects slow, medium or fast
measurement mode
X
20 (slow mode)
[SENSe:]CURRent:AC:RANGe
Selects the ac current range
X
Autoranging
[SENSe:]CURRent:APERture
Sets the integration time for current
measurements
X
1.67E-02
(60 Hz) or
2E-02 (50 Hz)
[SENSe:]CURRent[:DC]:RANGe
Selects the dc current range
X
Autoranging
[SENSe:]CURRent:NPLC
Sets the integration time in Power Line
Cycles (PLCs)
X
1
[SENSe:]CURRent:RANGe:AUTOmatic
Enables the autoranging function
X
1