The
Status
LED indicates whether the preamplifier is in operating state or in muted
state. When the LED light is on, the preamplifier is in operating state. When the
LED light is on and flashing, the preamplifier is in mute state. The LED is off
when the system is powered off.
The
Remote Receiver
window allows the transmission of signal from the remote
hand-held unit to be received by the preamplifier. Keep this window clear from
any obstruction to allow maximum signal transmission.
The
Power On/Off
switch can be used to turn the preamplifier on and off. Press
the switch up to turn the preamplifier ON and press the switch down to turn the
unit OFF. The
Status
LED should be on and off respectively, according to the
setting of the
Power On
switch.
The Preamplifier’s Back Panel
From the Preamplifier’s back panel, you can access the input, output, ground and
power connectors, the main fuse holder, and the serial number of the unit.
GND
Left
Right
Manufactured by:
TL 2.5 Stereo Preamplifier
VTL Amplifiers Inc.
4774 Murrieta Street Suite 10
Chino, CA 91710 USA
(909) 627-5944
For continuous protection
against fire hazard replace only
with fuse of same type and rating.
To prevent electric shock do not remove cover. No user serviceable parts inside.
Refer servicing to qualified personnel. To prevent fire or shock do not expose this appliance to rain or moisture.
Phono/Aux 2
Aux 1
CD
Tape
Tuner
Video
In
Tape
Out
In
Outputs
Processor
B
A
Inputs
1 A Slo Blo (120V)
.4 A Slo Blo (240V)
FUSE
Main Fuse
Serial Number and
Model Number Tag
AC Power Connector
Preamplifier Outputs
Processor Inputs
Tape Monitor
Inputs and Outputs
Line Stage Inputs
Phono Stage
Input
Phono Ground
Connector
TL2.5 Preamplifier Owner’s Manual
VTL
5
Summary of Contents for TL2.5
Page 1: ...VTL TL2 5 Line Stage Preamplifier Owner sManual...
Page 3: ......
