two configuration boxes and put the them across pins 4 and 5 and pins 9 and
10 respectively.
3.
Selecting MC
Jumpers on Phono PC board: (near MM Input pads). To set the phono stage
for MC, make sure both pins of the header are connected by the jumper.
Tubes on Phono PC board: (MC) – For MC mode, install the 12AX7A China
tubes to the tube sockets closest to the edge of the board (V2).
Jumpers on RCA Input PC board: there are two sets of jumpers for
configuring the phono board to MC. Please change the connectors on the
two configuration boxes and put the them across pins 3 and 4 and pins 8 and
9 respectively.
4.
Replace the cover
Put the cover of the preamplifier back onto the unit, and insert and tighten all
10 screws.
5. Connecting the turntable to the preamplifier
Connect the RCA input cables from the turntable to the Aux2/Phono RCA inputs
of the preamplifier. Loosen the binding post of the ground connection and place
the ground connector(s) from the input cables to the binding post.
6.
Power
the preamplifier and your amplifiers on and check to see that there
is no hum in the system. There should be a mild rush from both channels
at high volume, with no hum present. If you experience hum or any other
anomaly then please call the VTL factory for clarification.
TL2.5 Preamplifier Owner’s Manual
VTL
15
Summary of Contents for TL2.5
Page 1: ...VTL TL2 5 Line Stage Preamplifier Owner sManual...
Page 3: ......
