User Manual Digicom3100SP Multi-screen Processor
53
Slot 13-15 in the rear: ArkLink4 channel processing output board GPA-340;
Slot 16-18 in the rear: System CPCI power supply;
Note:
For 6-channel RGB collection interface board RA-361, please install the right slot first, and then install to
the left in sequence. Similarly, remove the RA-361 on the left and then remove to the right in sequence.
5.4 Troubleshooting
1. The system isn’t started after pressing the power switch
Reason
1)
The general power switch isn’t turned on;
2)
Input power supply doesn’t comply with the requirement;
3)
The switch on power supply module is on “OFF” position;
4)
Other unknown reasons.
Solution
1)
Check whether the general power supply of the Multi-screen signal processor is turned on; if
not, please turn on the general power supply and then turn on the Multi-screen signal
processor;
2)
Check whether the input power supply complies with the requirement.
Note: Please make sure that the power supply of the Multi-screen signal processor complies
with the requirement of the device, or else it may damage the device, or even hurt the
operators;
3)
Move the power switch on the power supply module to “ON” position, and then press the
power switch of the Multi-screen signal processor;
4)
If the problem still isn’t solved, please contact VTRON or the distributor. We will reply as
soon as possible.
2. the power supply of the Multi-screen signal processor is in normal state, but there isn’t
image on the display terminal after pressing the power switch, and the processor doesn’t
