R E I M A G I N E
L O U D S P E A K E R S
WWW.VUEAUDIO.COM
1. Power LED indicator
2. Amplifier indicators for: Protection and Temperature
3. Sleep indicator lights when the amplifiers is in power
down sleep mode.
4. Wink indicator for identifying the amplifier over the
network.
5. Input channel meters with input Clip, input Limiter
engaged indicator, -6dB down from full input, and
Signal present indicator.
6. Input channel audio Mute indicator.
7. Output channel Amplifiers 1, 2 and 3 meters with output
Clip, output Limiter engaged indicator, -6dB down from
full output, Signal present, and channel mute indicator.
8. Output channel Amplifiers 1, 2 and 3 Mute indicators.
9. Front cooling vent - Do not block vent openings and
clean vent filter when visibly dirty.
1. AC Power switch
2. Locking PowerCon connector (100 - 240VAC, 50-60 Hz)
3. Cooling fan (rear exhausting, air is pulled in the front of
the amp) do not to block the fan opening.
4. Speaker output - Single NL8 Speakon connector
5. Analog input and hard wired loop through XLR jacks.
6. AES / EBU digital input and buffered loop through XLR
jacks.
V3-i REAR PANEL FEATURES
V3-i FRONT PANEL FEATURES
7. Two Ethernet port jacks for control with SystemVue
network software and audio input with Dante network
audio. Either port can be used. These jacks are
individual ports on an internal Ethernet switch, so they
can be linked to the next VDrive amplifier in a rack.
When using an external Ethernet switch one
jack should be connected to the network
switch. Connecting both ports to the same
network will cause continents on the network.
Summary of Contents for VUEDrive V242
Page 3: ......
