12
PROBLEM
PROBLEM CAUSE
CORRECTION
Tool does nothing
or
operates sluggishly.
Inadequate air supply.
Inadequate lubrication.
O-rings or seal is worn
or damaged.
Make sure air supply is
adequate.
Place two or three drops
of oil to the air inlet of the
tool
Air is leaking near
the
bottom of the tool.
Loose screws.
O-ring is possibly worn
out.
Tighten the screws.
Replace damaged or
worn
Tool is jamming
frequently
Incorrect fasteners
Damaged Fasteners.
Magazine or nose screws
are loose.
Magazine is dirty.
Driver is worn or damaged.
Supply approved
fasteners
of the correct size.
Replace undamaged
fasteners.
Tighten screws.
Clean magazine.
Replace damaged or worn
Other
Contact technical support
1-800-482-0131
Summary of Contents for 839-8224
Page 15: ...15 SCHEMATIC DRAWING...
