-
15
-
USING THE GRIDDLE
To preheat, turn the burners on about 20 -25 minutes before cooking.
A uniform and systematic approach to loading the griddle will produce the most consistent
product results.
The griddle plate is steel, but the surface is relatively soft and can be scored or dented by
careless use of a spatula or scraper. Be careful not to dent, scratch, or gouge the plate
surface. Do not try to knock off loose food that may be on the spatula by tapping the
corner or the edge of the spatula on the griddle surface.
ZONE COOKING
This griddle features a tubular U-
shaped burner in 12” sections, each controlled by
independent thermostats (900RX, MSA and ASA models) or manual valves (AGM
models)
. Each 12” section is a separate cooking zone, and allows cooking a wide variety
of products over a single griddle plate. The chart below is a suggested usage of zone
cooking.
When zone cooking, it is suggested that you start with your lowest temperature setting at
either side of the griddle, increasing the zone temperature as you move up the zone line.
These zone cooking guidelines will vary depending on product temperatures, size and
shape. This guide should be adjusted to suit your product and operational cooking
preference.
ZONE 1
(300°F)
ZONE 2
(350°F)
ZONE 3
(350°F)
ZONE 4
(400°F)
PRODUCT
S a u s a g e
E g g s ( H a r d F r i e d )
E g g s ( S c r a m b l e d )
B u r g e r (W e l l D o n e )
S t e a k (W e l l D o n e )
C h i c k e n B r e a s t
F r o z e n F o o d s
P o r k C h o p s
PRODUCT
PRODUCT
S t e a k ( R a r e )
S t i r F r y V e g e t a b l e s
S a l m o n
F i s h C a k e s
L o b s t e r
S c a m p i
P a n c a k e s
F r e n c h T o a s t
B a c o n
O m e l e t
H a s h B r o w n s
C a n a d i a n B a c o n
E g g s ( S u n n y S i d e U p )
B o i l e d H a m
S t e a k ( M e d i u m W e l l )
F r e s h B u r g e r ( M e d i u m W e l l )
S m a l l F r o z e n B u r g e r ( M e d i u m W e l l )
Summary of Contents for 900RX Series
Page 24: ... 24 SIDE VIEW FRONT VIEW 4 3 ...
Page 25: ... 25 NOTES ...
Page 26: ... 25 REMARQUES ...
Page 27: ... 24 PROFIL VUE DE DEVANT 3 4 ...
