REMOVAL AND REPLACEMENT OF PARTS
BURNER
1.
Remove FRONT PANEL and REAR PANEL.
2.
Disconnect gas supply at griddle.
3.
Remove screw securing burner to wall.
4.
At rear of unit, pull burner enough to disengage
burner pin from frame and pull burner out.
5.
Install in reverse order.
6.
Adjust as outlined in BURNER ADJUSTMENT.
PILOT, THERMOCOUPLE
ASSEMBLY
1.
Remove FRONT PANEL.
2.
From underneath the front of the griddle,
remove screw securing pilot assembly bracket.
3.
Carefully lift to disengage bracket from slot and
work assembly down to access parts.
4.
Service assembly as required and assemble in
reverse order being sure bracket is seated in
slot for alignment.
VIEW FROM REAR OF UNIT TO SEE PARTS
F25383 (510)
Page 8 of 16
