REMOVAL AND REPLACEMENT OF PARTS
COVERS AND PANELS
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
FRONT PANEL
1.
Turn all thermostats to off position, loosen set
screw securing thermostat knobs and pull off
knobs.
NOT IN OFF POSITION FOR VIEW
Fig. 4
2.
Remove screws securing front panel to griddle.
3.
Pull front panel forward and lay aside. If servicing
a 900RX lay front panel face down in front of unit.
4.
Install in reverse order.
NOTE:
Before installing front panel, check that lineof-
sight through the front panel to see both pilot burners
and griddle burners. Move any flexible gas tubing, or
capillary tubing that may obstruct the sight holes.
Fig. 5
BACK PANEL
Shut off the gas before servicing the
unit and follow lockout / tagout
procedures.
All gas joints disturbed during servicing must be
checked for leaks. Check with a soap and water
solution (bubbles). Do not use an open flame.
NOTE:
It will be necessary to remove the back panel
when changing a burner or to remove excessive
grease build up from flue area.
1.
Disconnect gas supply at griddle.
Remove screws securing back panel to griddle.
Install in reverse order.
MOMENTARY POWER SWITCH
(900RX)
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
1.
2.
Label and disconnect wires from power switch.
3.
Squeeze switch retainers and slide switch out
through front of panel.
Fig. 6
4.
Install in reverse order.
Heavy Duty Gas Griddles - REMOVAL AND REPLACEMENT OF PARTS
F25383 (0219)
Page 6 of 19
