Page 8
Bell TV SD
Bell TV SD and HD
MUST SHOW
“SW21”
NO “X”s
“NO SWITCH
DETECTED”
or
“INSTALLED
DEVICE
UNKNOWN”
or
similar
If the indicated results are not obtained, go back to Step 3 and run test again. Contact King
Controls if the check switch fails to load after 4 attempts.
8.
When the installation summary shows the successful check switch test results, save the
settings, exit to the main menu screen and wait for programming to download.
9.
DISH SD and HD
and
DISH SD and HD Alternate
only: Verify that your saved settings show
your desired satellite trio: 61.5, 110, 119 or 110, 119, 129. To switch trios, see pages 4-5.
Confi guration is complete. Go to page 10, OPERATION.
DISH SD and HD Alternate
DISH SD and HD
NO “X”s
MUST SHOW
“SW64”
Summary of Contents for FLEX VQ2100
Page 2: ......
Page 11: ...Page 9 This page intentionally left blank ...
Page 30: ...Page 28 NOTES ...
Page 31: ......