Page 11
SCAN FOR SATELLITES
1. Press and hold
SCAN
for 3 seconds.
•
The antenna will scan for the selected satellites. The four
SCAN PROGRESS
lights will
cycle on and off to indicate a scan is in progress.
•
As satellites are located, the corresponding
SCAN PROGRESS
lights will turn on (see
below).
•
When scan is complete, the appropriate lights will turn on to show which satellites were
found.
•
Wait for the program guide to download and then select your desired channel.
NOTE:
If you move the antenna unit, you will have to re-acquire the satellites by repeating the scan process. The
FLEX will go into “sleep mode” after 15 minutes and the
COAX
CONNECTION
light will dim. Press
POWER
to
wake unit up if necessary, i. e. the unit is in sleep mode, you move the unit, and wish to rescan for satellites.
DISH AND BELL TV SUBSCRIBERS:
If you are using a second receiver, see SECOND RECEIVER OPERATION -
DISH AND BELL TV on page 22.
Use this chart to determine which satellites have been found.
NOTE:
The order of the lights corresponds to the order of the satellites listed.
Example for
DISH SD
: The 110 satellite corresponds to Light 1, and the 119
satellite corresponds to light 2.
Summary of Contents for FLEX VQ2100
Page 2: ......
Page 11: ...Page 9 This page intentionally left blank ...
Page 30: ...Page 28 NOTES ...
Page 31: ......