Page 12
1.
If your FLEX controller is not on, press
POWER
and wait for the
COAX CONNECTION
light to
stop fl ashing and remain on.
2.
Plug your receiver and TV into a 110 volt AC power source.
The green light on your receiver should illuminate or begin cycling on and off. Wait for the
green light to turn solid (this may take up to two minutes).
If the green light does not illuminate after a few minutes, power on your receiver using the
front panel power button.
Section 5
TAILGATER MODE
3.
Turn on your TV. Use your TV’s input selection menu to select the input that matches the
connection to your DISH receiver, i. e. if using an HDMI cable connection you should select the
HDMI TV input.
IMPORTANT: If you have a DISH receiver model ViP211z, ViP211k, ViP211 or 411 AND have confi gured the
antenna for the DISH SD and HD setting, use the instructions on this page.
IF YOUR RECEIVER IS NEW AND NOT YET ACTIVATED, YOU MUST PERFORM THE FIRST TIME
SETUP ON PAGE 16 BEFORE USING THE INSTRUCTIONS ON THIS PAGE.
Your local channels may not be available when traveling outside your home area.
See page 4 for
confi guration details.
IMPORTANT!
The antenna unit requires a
“direct line of sight” to the
satellites for signal reception.
Any tall objects can block the
signal from reaching the dish.
Summary of Contents for FLEX VQ2100
Page 2: ......
Page 11: ...Page 9 This page intentionally left blank ...
Page 30: ...Page 28 NOTES ...
Page 31: ......