Page 22
Section 6
SECOND RECEIVER OPERATION - DISH AND BELL TV
INITIAL SETUP FOR SECOND RECEIVER
1.
With the second receiver disconnected from
the dome unit’s AUX port coax, use your
DISH remote control and press
MENU
,
6
,
1
,
1
to display the
Point Dish
screen.
2.
Use the arrow buttons on the remote
to highlight “Check Switch.”
Press
SELECT
on your remote.
5.
After successfully saving the results, connect the AUX port coax to SAT IN on the second
receiver.
See the next page for downloading programming to the second receiver.
3.
Verify “SuperDISH” and “Alternate”
are not selected.
Verify “Test” is highlighted.
Press
SELECT
on your remote.
4.
When test is complete, highlight “Save.”
Press
SELECT
on your remote.
IMPORTANT!
Second receiver must
be disconnected during
initial confi guration.
Summary of Contents for FLEX VQ2100
Page 2: ......
Page 11: ...Page 9 This page intentionally left blank ...
Page 30: ...Page 28 NOTES ...
Page 31: ......