Using Your Video Eyewear
Before using your video eyewear for the first time, remove the clear peel-
back lens protection film from the inside surface of the viewer lens and
charge the battery (
see Charging
).
The iWear AV920 video eyewear can be connected to any 2D or 3D
video devise with compatible connectors. The AV920 will sense if the
video signal is PAL or NTSC and automatically adjust.
Multi-function Control Wheel/Button
A multi-function Control Wheel is
located under the right-front corner of
the video eyewear display unit.
Rotating the multi-function wheel
enables the selection of menu options
and adjusts settings. When pressed, it
functions as a dual action button. A
quick press and release selects menu
options while a press and hold (3 or
more seconds) provides a second
level of button commands.
Power On/Off
:
Press and release to turn on the eyewear.
Press and hold for 3 or more seconds to turn off the
eyewear. It will also turn off automatically if no video
signal is available for several minutes.
Adjust Volume
:
Rotate to turn speaker volume up or down.
Available
only when the OSD is not displayed.
Access OSD
:
Press and release to access and dismiss the OSD
(on screen display) menu.
OSD Menu
:
Rotate to change menu selection. Press and release
to select an OSD menu item.
On Screen Display Menu (OSD)
When you press and hold the Control Wheel for more than 3 seconds,
the following menu commands will appear horizontally across the lower
section of your iWear display. These commands will allow you to adjust
the display settings of your video eyewear.
