English |
43
The warning message “Mark Rivet” prompts you to
mark the rivet and then to continue riveting in order
to finish the job.
In this case the set rivet is not counted. Remove
the faulty rivet and set it again.
Acknowledge the error message by pressing the
“OK key” (T).
The warning message “Replace Rivet” prompts you
to remove the rivet, e.g. by drilling out the faulty
rivet, and then to continue riveting in order to finish
the job.
In this case the set rivet is not counted. Remove
the faulty rivet and set it again.
Acknowledge the error message by pressing the
“OK key” (T).
The warning message “Abort Job” prompts you to
end the job.
This part is then discarded without riveting being
completed.
Acknowledge the error message by pressing the
“OK key” (T) to start a new job.
