P
ACKAGE
C
ONTENTS
Dylastir Stirrer, Dylatherm Hotplate, or Dyla-Dual Hotplate-Stirrer
72" (183cm) power cord
Stir bar (stirring models only)
Instruction manual
W
ARRANTY
Manufacturer warrants this product to be free from defects in material and workman-
ship when used under normal conditions for two (2) years. Register your equipment or
instrument
online
at:
www.vwrsp.com/warranty
for
US
residents
or
www.vwrcanlab.com/warranty for Canadian residents. For your reference, make a note
of the serial number, date of purchase and supplier here.
Serial No.:________________________Date of Purchase:_______________________
Supplier:______________________________________________________________
T
ABLE OF
C
ONTENTS
Package Contents
. . . . . . . . . . . . . .
1
Warranty
. . . . . . . . . . . . . .
1
Installation
. . . . . . . . . . . . . .
1
Maintenance & Servicing
. . . . . . . . . . . . . .
1
Environmental Conditions
. . . . . . . . . . . . . .
1
Safety Instructions
. . . . . . . . . . . . . .
2
Specifications
. . . . . . . . . . . . . .
2
Stirring Operating Instructions
. . . . . . . . . . . . . .
2
Heating Operating Instructions
. . . . . . . . . . . . . .
3
Replacement Parts
. . . . . . . . . . . . . .
3
1
I
NSTALLATION
Upon receiving the VWR Dylastir/Dylatherm/Dyla-Dual, check to ensure that no damage
has occurred in shipment. It is important that any damage that occurred in transport
is detected at the time of unpacking. If you do find such damage the carrier must be
notified immediately.
After unpacking, place the Dyla Series unit on a level bench or table, away from
explosive vapors. Ensure that the surface on which the unit is placed will withstand
typical heat produced by the unit and place the unit a minimum of six (6) inches from
vertical surfaces. Always place the unit on a sturdy work surface.
The Dyla Series unit is supplied with a 3-prong power cord that should be plugged into
a standard 3-prong grounded outlet. If the cord supplied does not meet your needs,
please use an approved power cord that suits local codes and electric supply.
Replacement of the plug must be made by a qualified electrician.
M
AINTENANCE
& S
ERVICING
The Dylastir/Dylatherm/Dyla-Dual is built for long, trouble-free, dependable service.
No lubrication or other technical user maintenance is required. It needs no user
maintenance beyond keeping the surfaces clean. The unit should be given the care
normally required for any electrical appliance. Avoid wetting or unnecessary exposure
to fumes. Spills should be removed promptly after the unit has cooled down. Do not
use a cleaning agent or solvent on the front panel which is abrasive or harmful to
plastics, nor one which is flammable. Always ensure the power is disconnected from
the unit prior to any cleaning. If the unit ever requires service, contact your VWR
representative.
E
NVIRONMENTAL
C
ONDITIONS
Operating Conditions:
Indoor use only.
Temperature: 5 to 40°C (41 to 104°F)
Humidity:
20% to 80% relative humidity, non-condensing
Altitude:
0 to 6,562 ft (2000 M) above sea level
Non-Operating Storage:
Temperature: -20 to 65°C (-4 to 149°F)
Humidity:
20% to 85% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with IEC 664.
