26
vwr.com I Instruction manual VWR® U Water System
Step 1 Remove the knob and the barb connector from the package. Twist on the barb connector to
the knob, then remove the yellow tape from the O-ring.
Step 2 Screw on the assembled faucet to the tank until its finger tight.
c)
Screw the quick connector into the tank water inlet. Insert the two 8 mm elbow plugs
provided into the tank water inlet and outlet respectively.
Take the 8 mm tubing out from the
system accessories bag, cut two pieces in proper length of tubing to link the tank to the
system.
d)
Insert one end of the first 8 mm tubing into the
INLET
port at the top of the PE tank and the
other end into the
Product To Tank
on the system.
e)
Insert one end of the second 8 mm tubing into the
OUTLET
at the base of the PE tank and
the other end into the
Pure Water In
on the system.
f)
Screw the Tank Vent Filter to the top of the PE tank (see picture Tank Top View).
g)
Connect the cable plug from the tank level sensor to the
Level Sensor
port on the back of
the water system
h)
Connect the cable plug from the overflow sensor to the Overflow Sensor port on the back of
the water system.
Note
: If UV sanitization module is installed, skip the step
h
.
Cable plug connected to
the Level Sensor port at
the back of the system
Cable plug connects the
Overflow Sensor port at the
back of the system