Operating Your Cleaner with Ultrasonic, Heating & Degassing Feature
Before you start cleaning:
WARNING
Don
’t place parts or containers directly on the bottom of the cleaning tank; use a
support rack, wire or beaker cover to suspend items.
The water surface should not be lower than
“MIN.LEVEL”
to prevent damages to
heating device.
Don
’t ever use alcohol, gasoline or flammable solution. Doing so could cause a fire
or explosion. Use only water-based solutions.
Don
’t ever use mineral acids or bleaches. These could damage the tank.
Step
1.
Select your cleaning solution.
2.
Allowing for the volume of the parts you will be cleaning and cleaning solution, fill
the tank with warm tap water to the operating level line.
3.
Add cleaning solution to the tank water.
4.
Plug the cleaner into a grounded outlet.
Cleaning items:
Step
1.
Set the TIMER for the amount of time you wish the items to be cleaned.
2.
Place the items into a basket or beakers in a positioning cover.
3.
If using beakers, add cleaning solution to beakers to cover the items.
4.
Slowly lower the basket or beakers into the tank. Do not allow items to contact the
tank bottom. Do not stir the solution.
5.
When items are clean, slowly remove them from the cleaner.
6.
Rinse the clean items with clean water and dry them, if necessary.
！
23
Summary of Contents for 97043-930
Page 28: ......
