VXI Technology, Inc.
6
CT-310A Preface
G
ENERAL
S
AFETY
I
NSTRUCTIONS
Review the following safety precautions to avoid bodily injury and/or damage to the product.
These precautions must be observed during all phases of operation or service of this product.
Failure to comply with these precautions, or with specific warnings elsewhere in this manual,
violates safety standards of design, manufacture, and intended use of the product.
Service should only be performed by qualified personnel.
T
ERMS AND
S
YMBOLS
These terms may appear in this manual:
Indicates that a specific
WARNING
or
CAUTION
follows.
WARNING
Indicates that a procedure or condition may cause bodily injury or death.
CAUTION
Indicates that a procedure or condition could possibly cause damage to
equipment or loss of data.
These symbols may appear on the product:
WARNING
Indicates that a procedure or condition may cause bodily injury or death.
!
ATTENTION
- Important safety instructions
Frame or chassis ground
Alternating Current (ac)
Indicates that the product was manufactured after August 13, 2005. This mark is
placed in accordance with
EN 50419, Marking of electrical and electronic
equipment in accordance with Article 11(2) of Directive 2002/96/EC (WEEE)
.
End-of-life product can be returned to VTI by obtaining an RMA number. Fees
for take-back and recycling will apply if not prohibited by national law.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
