VXI Technology, Inc.
26
CT-100B Installation
R
ACK
M
OUNT
D
OOR
K
IT
I
NSTALLATION
The rack mount door kit (Option 60) provides the necessary hardware to install a 1/8” thick
aluminum door in front of the rack mounted chassis. This option requires that the rack mount ear
kit also be installed and configured for recessed mounting. The door may be customer modified
to hold connectors, controls, indicators and similar components.
R
EQUIRED
T
OOLS
1. #2 Phillips Screwdriver
2. 1/8" Flat Blade Screwdriver
3. 11/32" Open Ended Wrench
P
ARTS
L
IST
QTY
ITEM
VTI P/N
2
Slide, Rack Mount, Steel, 20"
37-0054-020
1
Hardware Kit, Rack Mount Slide, Steel
37-0055-000
6
Screw, 8-32 x 3/8" Pan Head Phillips, Sems Zinc
37-0073-037
6
Screw, 8-32 x 1/4" Pan Head Phillips, Steel/Zinc
37-0074-025
4
Screw, 8-32 x 3/8", F/H Undercut Phillips, Zinc
37-0115-037
2
Bracket, Slide, Front, 5 Slot Chassis, CT-100B
41-0108-000
1
Bracket, Slide, Top Side, CT-100B
41-0131-000
1
Bracket, Slide, Bottom, CT-100B
41-0132-000
A
SSEMBLY
P
ROCEDURE
1. Lay the chassis on a protected work surface on its long side with the voltage monitor LEDs of
the chassis facing front with the power switch toward the top.
2. Locate two rackmount (cross) braces. Install one each along the front of the flanges (one on
top and one on the bottom) using four (two ea.) #8 flathead screws. The lip along the long
edge of each brace goes toward the front and pointing inside. The braces fit over the flanges
and the screws are placed from the inside going through the flange and then into the brace.
3. Locate the front door and two hinges. Install the two hinges to the front door using four
black screws provided.
4. Locate the latch kit and install it into the door from the side where the hinges are mounted.
5. Locate the door latch bracket and install it on the rack mount ear opposite the end where the
hinges will be installed. Use the rack mount door installation diagram below as a reference.
6. Locate the four tapped holes on the front surface of the rack mount ear to which the door is to
be attached.
7. Install the door by its hinges to the rack mount ear using four black screws provided with the
option kit.
8. Test that the door opens and closes smoothly and adjust the latch as necessary to secure the
door when latched close.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
