Vynco E1V2, User'S Operating Manual

WWW.VYNCO.CO.NZ

6

To stop charging your electric vehicle

1. Check that the charger is still charging or has finished charging.

If LED is flashing green – vehicle is still charging. The charging can be stopped if required. 

If LED is blue – vehicle has finished charging and the battery should be at 100%.  

2. Remove the charging lead from the vehicle.

Follow the vehicle manufacturer’s instructions to remove the charging lead. 

Some vehicles require the doors to be unlocked or a charging button to be pressed before 

the lead can be unlocked and removed. 

3. Remove the charging lead from the charger.

If the plug cannot be easily removed from the charger push the plug in firmly and then try to 

remove the plug again. If the plug will still not come out – push in the red stop button on the 

side and then try to remove the plug again.  

4. Check that the LED status on the charger has turned blue.

The charger is now ready to charge another vehicle. The plug must be removed from the 

charger each time before you charge a vehicle. This resets the safety protocols built in 

to the charger. If the LED status is Red – check that the Red Stop Button is out. Twist to 

release if pushed in.   

OPERATING INSTRUCTIONS

PRESS