ASSEMBLY
EXTREME CARE SHOULD BE USED DURING ASSEMBLY TO
PREVENT INJURY TO HANDS, FINGERS AND FEET.
1. Mount the tool bar, gauge wheels and three point hitch assembly on the tractor three
point hitch.
2. Attach Shank Assemblies (A) to tool bar at desired spacing. If planting on the flat, row
widths may vary from field to field. Closer furrows (30”) on lighter soils to 60” on heavier
soils.
3. Using 5/8” x 2” Bolt, Lock Nut and Flat Washers provided, install Pick Up Arm (B) to
Shank Assembly. When on a folding tool bar, wing mounted Pick Up Arms must be turned
so that chain side is facing center of machine.
4. Attach Torpedoes (C) to Pick Up Arms using Quick Links (D) provided. Quick links must
be wrench tightened. Front chain (E) in third link of chain and rear chain (F) in first link of
chain. Rear chain must be slack when unit is in operation so Torpedo will run level and
be able to rotate.
5. IMPORTANT: Mount Parking Stands on rear side of tool bar to provide stability when
unit not in operation. Always unfold wings before placing unit in storage.
7
