2
1.5
SYMBOLS DISPLAYED ON THE STERILIZER
Consult this table whenever one you see one of these symbols in this manual or on the sterilizer.
ATTENTION
Where this symbol is displayed on the sterilizer, the user must refer to this document.
When shown in the user manual this symbol means ATTENTION IMPORTANT NOTES.
To disregard the instructions given in this manual, incorrect use, poor maintenance or
servicing by unauthorized personnel, clears the manufacturer of any responsibility for
warranty and any other claims
.
HOT SURFACES
This symbol is displayed at the front of the sterilizer beneath the chamber door. It re-
minds the user to take special care to avoid burns when dealing with the sterilization
load, the sterilization chamber, the chamber door and the area around the chamber
door.
The material the sterilizer is composed of must be disposed according to the directive
2002/96/CEE.
1.6
GENERAL AND SAFETY RECOMMENDATIONS
o
The user is responsible for the proper installation, the correct use and maintenance of the steri-
lizer in accordance with the instructions listed in this manual. For further information call your
local service provider.
o
The sterilizer has not been designed for the sterilization of liquids.
o
The sterilizer must not be used in the presence of gas or explosive vapours.
o
The chamber is automatically heating to 120°C as s oon as the sterilizer is switched on.
o
The trays and the sterilization load will be hot at the end of each cycle. Use tray or cassette
holders to empty the sterilization chamber.
o
Do not exceed the maximum load weight limits as specified in this manual (see § 7.1)
o
Do not remove the name plate or any label from the sterilizer.
o
To avoid electrical short circuits, do not pour water or any other liquid over the sterilizer.
o
Switch off the sterilizer and unplug the mains cable before inspecting, carrying out maintenance
or servicing the sterilizer.
o
Repairs, maintenance or service must be carried out by authorized W&H service technicians
only with the use of original spare parts.
o
In case of transport:
-
Drain both water tanks completely (§ 5.5).
-
Allow the sterilization chamber to cool down.
-
Use original or appropriate packaging
.
Not observing the instructions as specified in this manual can lead to unsafe opera-
tion for the user.
Summary of Contents for Lisa
Page 1: ...Instruction for use UM009ENG LISA FULLY AUTOMATIC 201 10 Rev 4...
Page 2: ......
Page 77: ......
