Installation on a Speaker Stand
The speakers may only be installed on a speaker stand if the
original speaker is equipped with an
appropriate stand adaptor.
Stands must only be installed on a plane area with a
maximum inclination angle of 5˚.
CAUTION:
Speakers installed under the influence of
horizontal forces, e.g. wind, can be impaired. This is why
additional safety measures like attaching ballast weights
have to be taken.
If inclined tension cables or prolonged outriggers are used.
the area of danger has to marked or blocked.
Before lifting or lowering the telescopic tubes, you must
always block a safety area around the stand. This safety area
must have a diameter of 1.5 times the maximum height.
Lifted telescopic tubes always have to be secured with a
secondary securing attachment.
The total weight of the installation (total weight of system
including individual parts) must never exceed the maximum
load of the installation area.
Unintended movement of the load has to be avoided - also in
case of fire!
Loosen the fixing screws of the legs, pull the legs out until the
cross struts are at a 90˚ angle to the legs. Tighten the fixing
screws of the legs.
Installation Of The Speaker
CAUTION:
The loads have to be installed in a balanced way.
CAUTION:
The carrying capacity of the stand or speaker stand must never be exceeded.
7
Summary of Contents for SPEA38 - DSR 12
Page 1: ...ENGLISH USER MANUAL Order Code SPEA38 DSR 12 Order Code SPEA39 DSR 15...
Page 4: ...3...
Page 12: ......
