3 x 1 CONTROLLER/SWITCH
REAR PANEL CONTROLS
9
7
8
10
(7)
(8)
3 x 1
(9)
(10)
GROUND CONNECTOR
COAX RF INPUTS
3 X 1 COAX RF OUTPUT
POWER IN
Station ground should be connected here.
These three coax inputs are used to connect RF devices
such as transceivers or RF linear amplifiers to the
Controller / Switch. The front panel mounted
Local / Remote Input Switch is used to select which one of
the three RF inputs is connected to the 3 x 1 RF Output.
This coax output is connected to one of three coax inputs
(see text above). Which input is connected to the output
is determined by the position of the front panel mounted
Local / Remote Input Switch.
This 6 pin DIN Connector is used to provide DC power to
the unit. Power requirements are 10 to 15 VDC at 1 AMP
for Powering one Controller and one 1 X 4 Antenna Switch.
The power required for two Controllers and two 1 x 4
Antenna switches is 10 to 15VDC at 2 AMPs.
+ 10 to 15VDC
GND
Power
6 Pin Male DIN
Din connectors shown
on side to be soldered
-6-