Manuale d’istruzioni
Instruction handbook
13
6.1.3.
Vacuum Function
-
The Vacuum function allows to activate the extraction of the air from
the bags. The vacuum parameter is expressed in second and the formulations of the time
must be adapted to the effective operating requirements in how much the necessary time
for the VACUUM one vary based on the dimensions of the product to Manifacturer.
6.1.4.
Welding Function
-
After the execution of the vacuum, the device proceeds to the
welding of the bags by means of the appropriate knitting bar tiny of resistance electrical
worker. The welding time differs on the characteristic of the bags, on the temperature and
to the amount of vacuum that is wanted to be carried out. In any case, the welding must
be uniform. For bags of 09/100 gr. is needed to program “timer” to 2 second , for bags
from 100/150gr. to 4 second.
6.1.5.
Automatic Function
1)
Put the plug in the socket of 220V.
2)
Press the general switch.
3)
Regulate the time of vacuum to about 15/25 seconds turning the vacuum potentiometer.
4)
Regulate the time of welding to about ¾ seconds turning the welding temporizer.
5)
Put the good in the bag.
6)
Put the bag, turned to “elle”, under the stainless steel bar.
7)
Lower the cover pressuring on it until it is closed, with the air aspiration.
8)
It makes the welding operation.
9)
The opening of the cover is automatic after the working cycle.
6.1.6.
Semi-automatic function
1) Insert the plug in the socket of 220V.
2) Press the general switch.
3) Regulate the time of vacuum to about 15/25 seconds turning the vacuum potentiometer.
4) Regulate the time of welding to about ¾ seconds turning the welding temporizer.
5) Put the good in the bag.
6) Put the bag, turned to “elle”, under the stainless steel bar.
7) Lower the cover pressuring on it until it is closed, with the air aspiration.
8) When the bag is perfectly adherent to the good, press the push-button “SEAL”, it makes
the welding operation.
9) The opening of the cover is automatic after the working cycle.
7.
TEFLON REPLACEMENT ON THE WELDING BAR
After a long period of use of this machine, is needed to change the welding bar in the following way:
►
Disconnect the power feeling and make sure that the bar is cold.
►
Disconnect the cables of the bar pressing the superior part of the “fastom”.
►
Remove the bar from the guide.
