47
Component Replacement Procedures
The OnSide BSD LED indicator is mounted on the passenger side A-pillar near the right-side view mirror.
(Figure 7.3).
The OnSide BSD LED indicator is attached to the passenger side A-pillar using plastic ribbed push rivets.
(Figure 7.4). The “Pig Tail” harness cannot be removed from the BSD LED indicator. (Figure 7.5).
Fig. 7.4
4016877a
Fig. 7.5
4016876a
Fig. 7.5
Removal
1. Turn the ignition switch to the OFF position.
2. Using a fl at blade or panel tool, gently pry the OnSide BSD LED indicator loose from the A-pillar trim
panel and remove it from the A-pillar trim panel.
CAUTION
Make sure not to damage the OnSide BSD LED indicator or the A-pillar trim panel during removal.
3. Carefully pull the OnSide BSD LED indicator pig tail from the access hole in the A-pillar until the
connector can be accessed (Figure 7.5).
4. Disconnect the OnSide BSD LED indicator pig tail from the harness connector.
Installation
1. Connect the OnSide BSD LED indicator pigtail connector to the A-pillar harness connector.
2. Gently feed the OnSide BSD LED indicator pigtail and harness back into the A-pillar access hole.
3. Align the plastic ribbed push rivets (Figure 7.4) with the A-pillar mounting holes and gently press the
OnSide BSD LED indicator into place until seated against the A-pillar trim panel.
