18
Start-up
7.4
Initial start-up of EBS 3
WABCO offers EBS 3 as a universal system that must be adapted to the vehicle type in question
during start-up based on vehicle parameters. EBS 3 cannot function without such a configuration.
When the training model is delivered, EBS 3 is parameterised with an implausible standard
parameter set for safety reasons. Before using the training model for the first time, a one-off
start-up of the EBS 3 via the WABCO Diagnostic Software must be carried out. During start-up,
the parameters for the components installed on the training model are set.
Information on the installation and activation of the Diagnostic Software as well as the
required hardware can be found here:
See:
Â
chapter "9 Diagnosis and parameter setting", page 22
An EBS 3 system training is required in order to obtain a PIN for parameterisation or
creation of a parameter set.
You can find more information here:
See:
Â
chapter "9 Diagnosis and parameter setting", page 22
Carrying out the initial start-up
1. Connect the PC or laptop on which the Diagnostic Software is installed to the training model via
a Diagnostic Interface.
2. Switch on the ignition of the training model.
3.
Start the Diagnostic Software.
4. Select the menu item
Start-up
.
5. Start the parameter setting.
The training model is parameterised manually.
•
Manual parameterisation (creation of your own parameter set)
After starting the start-up procedure, a menu can be used to select which steps are to be carried out.
Some steps are mandatory and cannot be deselected.
Required steps:
•
Parameter setting
•
EBS pressure test
• Redundancy test
•
ABS sensor assignment
• Test of warning lamp control
Optional:
•
Testing the CAN lines
Only after a fully completed and successful start-up can all functions of the training model be used.
Summary of Contents for Truck Training Model
Page 1: ...Truck Training Model Operating Instructions...
Page 52: ...52 EEC declaration of conformity 14 EEC declaration of conformity...
Page 54: ...54...
Page 55: ...55...
