22
Diagnosis and parameter setting
9
Diagnosis and parameter setting
9.1
Introduction
The training model is fully diagnosable.
The WABCO Diagnostic Software for EBS 3 is required for diagnosis and parameterisation of the
training model. The Diagnostic Software offers numerous possibilities for carrying out diagnoses and
demonstrating the parameterisation of the EBS 3 braking system.
The Diagnostic Software provides numerous possibilities for carrying out diagnoses and
demonstrating the parameterisation of the EBS 3 braking system.
The graphic user interface of the Diagnostic Software is clearly structured and intuitive to operate.
Extensive help is also available within the Diagnostic Software.
The diagnostic cable is connected to the EBS-ECU via the CAN data bus. To carry out a diagnosis,
the Diagnostic Software must be installed on the connected laptop/PC.
9.2
System training and PIN
The diagnosis of the training model with the Diagnostic Software may be performed by any user.
For more information on WABCO Academy training courses, please visit:
https://www.wabco-academy.com/
For start-up and parameterisation of EBS 3 you need an authorisation in the form of a PIN.
You will receive this after completing an EBS 3 system training.
After successful completion of the training, WABCO will send you a PIN and a personal user ID for
the Diagnostic Software.
You can use this PIN to activate enhanced functions in the Diagnostic Software and thus carry out
the start-up of the training model or change the parameter settings.
Summary of Contents for Truck Training Model
Page 1: ...Truck Training Model Operating Instructions...
Page 52: ...52 EEC declaration of conformity 14 EEC declaration of conformity...
Page 54: ...54...
Page 55: ...55...
