50
5. Work table order no. 22310
5.1 Rotate and swivel the work table
The work table (3) can be swiveld by 360° and be rotated by its rotating unit (2).
To rotate the work table please proceed as follows:
1. Loosen clamping screw (2.1)
2. Rotate the work table (3) to the desired position
3. Retighten the locking screw (2.1)
To swivel the work table please proceed as follows:
1. Loosen clamping screw (2.1)
2. Remove the work table (3) from the rotating unit (2).
3. Loosen the locking screw (2.2) by approximately 3-4 mm using an Allen key.
4. Pull the rotating unit (2) out of the notches at the frontal sides.
5. Turn the work table to the required position and re-engage it in the notches (this adjustment can only be made in
steps of 15° each!)
6. Retighten the locking screw (2.1).
7. Replace the work table (3)
8. Retighten the clamping screw (2.2)
By loosen the clamping screw (1.1) the work table can be adjusted in its height respectively it can be rotated 360°
around the steel column (7).
5.2 Drawing and legend
Part no.
Pieces
Order no.
Designation
1
1
51006831-0007
Post mount
1.1
2
16191200008025
Screw
1.2
2
16193400008000
Nut
2
1
51006831-0008
Rotating unit
2.1
1
16191200008030
Clamping screw
2.2
1
16191200008045
Screw
2.3
1
16112500008001
Washer
3
1
51006831-0009
Work table
