55
10. Turning jig for drilling milling stands
10.3 Assembly for turning with a face plate
Secure the drilling milling stand to a stationary and absolutely level surface with four screws. Tighten all
screws on the drilling milling stand.
1. Loosen the clamping screw (1.1).
2. Turn the steel column (7) so that the hexagonal steel boom (11) is parallel with the long side of the base plate
(1).
3. Retighten the clamping screw (1.1).
4. Slide a machine support (9) onto one end of the hexagonal steel boom (11).
5. Tighten the clamping screws (9.3).
6. Now insert the clamping device (13) into the machine support (9).
7. Tighten the clamping screws (9.1).
8. Now clamp the drive unit in the clamping device (13).
9. Tighten the clamping screw (13.1).
10. Now clamp the face plate (17) in the drive unit.
11. Guide the hand steel rest (16) into one of the grooves of the base plate (1).
12. Align the hand steel rest (16).
13. Tighten the clamping lever (16.2).
14. The wood-turning jig is now fully installed and can be used.
10.4 Drawing for turning with face plate
