143
18. Coolant unit (optional)
18.1 Setting up the coolant unit
When mounting the coolant unit to a WABECO machine base cabinet, the appropriate bores are already
present. The machine base cabinet ensures a safe base for the milling machine or coolant unit.
If the coolant unit is secured to another suitable surface, the two through holes must be bored into the
surface by the client. For the positions of the two fixture threaded sockets (thread M8) of the coolant unit,
see diagram. The diameter of the through holes in the surface must be at least 9 mm.
18.2 Mounting of the coolant unit to the machine base cabinet (optional)
■
The coolant unit (2) is positioned, as shown, on the machine base cabinet (1).
■
The screws and washers required for assembly are included in the scope of delivery.
To screw the coolant unit to the machine base cabinet
proceed as follows:
1. Combine each screw with a washer
2. Open the door or the machine base cabinet
3.
Push the screws from below, through the bored holes in the machine base cabinet, into the fixture
threaded sockets and tighten using a Allen key of size 6
700
3
5
0
100
300
445
Summary of Contents for F1410 LF
Page 41: ...41 7 Fitting and removing the tools 42 6 Spannen und Ausdrücken der Werkzeuge 1 2 3 4 5 ...
Page 98: ...98 16 Drawings and legends 16 12 Spindle Z axis with ball screws 16 12 1 F1410 LF F1410 LF hs ...
Page 126: ...126 16 Drawings and legends 16 22 Support arm for control panel 1 2 3 4 5 6 8 9 5 4 7 9 8 ...
