Instructions:
Class 2 Constant Current Power Unit
CAUTION –
To reduce the risk of fire, electric shock or injury to persons:
•
Always turn off power at main switch prior to installation.
•
System intended for installation by a qualified electrician, in accordance with NEC and local regulations. Consult with
local inspector to assure compliance.
•
For use with LED loads.
Model
LD-700MA09-EDIM-IS
Input Voltage
120Vac,60Hz
Input Current
Max 0.1A
Output Current
700mA
Each Port Output Voltage
2-4V DC
Each Port Load
1-3PCS 1x3W LED Fixtures
Each Port Load Lead Wires
12-22AWG
Output Port
3 PCS
FEATURES:
•
700mA Constant Current for LED’s optimized and stable performance.
•
Capable of supplying power to a single LED fixture, or more LED fixtures at once.
•
Special circuit design to protect LED from high voltage pulse. Driver will automatically shut off if the fixtures are not
properly wired. In this event, unplug and check the wiring and then plug it in again.
•
For use with ELV dimmer.
INSTALLATION:
1. Loosen two cover screws and remove the cover. Inside there four separate sets of wiring terminals.
2. Push down one set of the wiring terminals and insert fixture’s red wire into the “+” terminal and the black wire into
the “-” terminal.
3. After connecting all the LED fixtures, secure the cover by tightening the two screws.
4. The product should be installed on the either internal or external surface of any indoor construction.
MOUNTING INSTRUCTIONS
Retain these instructions for future service and adjustments
615 South Street, Garden City, NY 11530
Tel: (516) 515-5000 Fax (516) 515-5050
www.waclighting.com
