INSTALLATION INSTRUCTION
InvisiLED Tunable White
T24-TW3
Waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Ave
Ontario, CA 91761
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program
. Oct. 2022
2.
3.
Measured a distance between power supply and DMX controller to the beginning of the tape run. Choose between two options below to wire
the power and data communication to the tape. When choosing wire, factor in voltage drop, amperage rating, shield/unshielded, and type (in-wall
rated).
Option A: Unshielded Cable 25 ft. maximum distance between power supply to the beginning of the tape
The WAC In wall rated 20 AWG unshielded cable can be used to wire between a power supply-Wireless DMX LED Controller to the beginning of
the tape up to 25 ft. Smaller gauge wire number (bigger conductor) can be used, but the maximum run length limitation remains at 25 ft. due data
communication distortion if it’s run over 25 ft. (See FIG. 3) Wire color connection is shown in Table 1.
Table. 1
Wire Color Connection
Wireless DMX LED Controller Terminal
Color
T24-EX3-* Cable
Tape marking
RED
RED
+24VDC (RED)
WHITE
WHITE
DATA (WHITE)
BLACK
BLACK
- (BLACK)
FIG. 3
Option B: Shielded data Cable 90 ft. maximum distance between power supply to the beginning of the tape
A shield data cable shall be used to connect between the power supply-Wireless DMX LED Controller to the beginning of the tape up to 90 ft. (See
FIG. 4)
ICE cable model number: Control Yellow is recommended. Product information can be found below:
https://www.icecable.com/products/control-yellow
For Plenum spaces, ICE cable Control Yellow Plenum is recommended.
https://www.icecable.com/products/control-yellow-plenum
Both drain and common conductor wires shall be connected to a black terminal of Wireless DMX LED Controller. Another end shall be connected to
the black wire of connector cable. The signal conductor shall be connected to the white terminal of Wireless DMX LED Controller. Another end shall
be connected to the white wire of connector cable. The power cable can be either shielded or unshielded cable. The bigger conductor yields less
voltage drop. The +24VDC polarity shall be connected to the red terminal on Wireless DMX LED Controller. Another end shall be connected to the
red wire of connector cable. The -24VDC or common conductor wire shall be connected to a black terminal of Wireless DMX LED Controller.
Another end shall be connected to the black wire of connector cable. (see FIG. 5)
T24-B-WT (5-3 terminal box) may be used to connect between 5 wires of shield cable to 3 wires of InvisiLED tape connector.
FIG. 4
Shielded Data Cable
90 FT MAX
