Chapter 1, About the ERV-750: Equipment Description
E.H. Wachs
Part No. 79-MAN-01, Rev. 3-0409
7
Figure 1-6. Press and hold the brake release button to
move the arm. When you release the button, the brakes
will re-engage and hold the arm stationary.
NOTE
There are two
holes in the arm
extension for the locking pin,
one at each end. Do not hold
the pin when you are sliding
the extension out. The pin
snaps into the hole to prevent
the extension from coming all
the way out of the arm.
3.
To extend the length of the telescoping lower arm, turn
the locking knob counter-clockwise and pull out the
locking pin. Pull the arm extension out to the position
you want, then tighten the locking knob to secure it.
When you pull the extension out to the end of travel,
the locking pin will snap into the hole at the end of the
extension.
Figure 1-7. To extend the arm, (A) loosen the locking
knob, (B) pull out the locking pin, and (C) pull the
extension out. When you have the extension at the
desired position, tighten the locking knob (A).
4.
To operate the ERV-750, remove the controller from
its storage cradle.
Brake release
button
A
B
C
Summary of Contents for ERV-750
