Wachs TRAV-L-VAC 300, Manual

       WACHS TRAV-L-VAC 300

10

PRE-VACUUM CHECKLIST:

1. Insure all scheduled maintenance has been

properly performed. See maintenance section
in manual or refer to maintenance decal on
TLV.

2. Insure that the hitch assembly has been

properly attached to the towing vehicle.

3. Check trailer brake lights and turn signals.

4. Check TLV-300 fuel level.

5. Make certain battery is charged and ready to start TLV-

300 engine.

6. Make certain suction hose and suction tubes are stored

on board TLV-300

7. Check drive belt tension. Adjust as necessary. (Refer to

drive belt tensioning diagram in Charts and Graphs
Section)

TRAV-L-VAC 300 SET UP PROCEDURE:

1. Position TLV system near work area.

2. Connect coupling of suction hose to coupling on vacuum

inlet port. ( Figure 1)

3. Connect coupling on suction hose to coupling on

suction tube.

4. Once assembly of these components is complete, unit

is ready for operation.

TRAV-L-VAC OPERATING PROCEDURE:

1. Start engine and allow to idle several minutes to properly

warm up. (Figure 2)

2. Ensure vacuum diverter valve is closed to achieve proper

suction through the suction hose. If diverter valve is open
no suction will be present at the wand opening.

3. Bring engine RPM up to full running speed.

4. Insert suction tube into valve box and drop down until

contact is made with either water or debris. Continue to

 SECTION IV

                             SET-UP AND OPERATION

Figure 1

Figure 2