BA 1001/1501/2001 us – Edition 3.3 * 12001b320.fm
3-9
Operation
3.6
Putting into operation
Safety instructions
• Use footholds and handles to access and leave the machine
• Never use control elements as handles
• Never get on a moving machine. Never jump off the machine
Putting into operation for the first time
Important information
• The machine may only be put into operation by authorized personnel
Selection and qualification of personnel, basic responsibilities
on page 2-4 and
Safety instructions regarding operation
on page 2-5 of this
Operator’s Manual.
• The personnel must have read and understood this Operator’s Manual before putting
the machine into operation.
• The machine may only be used in technically perfect condition in accordance with its desig-
nated use and the instructions set forth in the Operator’s Manual, and only by safety-
conscious persons who are fully aware of the risks involved in operating the machine.
• Go through the “Start-up” checklist in the following chapter.
Running-in period
Handle the machine carefully during its first 50 operating hours.
The future performance and service life of the machine are heavily dependent on the
observance of the following recommendations during the running-in period.
• Do not overload the machine, but at the same time do not travel too cautiously either,
as the machine will never reach its proper operating temperature
• Do not run the engine at high speed for extended periods
• Increase the load gradually while varying the engine speed
• Strictly observe the maintenance schedules in the appendix
