7 Transport
100_0201_tr_0004.fm
19
7
Transport
7.1
Preparing the machine
Carry out preparations
1. Decommissioning the machine.
2. Lean the machine upright against a solid object and secure from tipping over.
3. Allow the machine and engine to cool down.
7.1.1
Removing the fuel system
4. Remove dirt accumulation in the area of the fuel cap.
5. Unscrew the fuel cap and remove.
6. Pump the fuel into a suitable container or tank, e.g. with a suction lift pump.
7. Attach the fuel cap and tighten.
8. Start the engine and allow it to idle until the fuel in the carburetor has been used and the engine stops.
WARNING
Improper handling may result in injury or serious material damage.
Please read and follow all safety instructions in this operator's manual.
WARNING
Danger from falling.
Falling machines can cause serious injuries from crushing.
Only use suitable and tested lifting gear and slings with sufficient lifting capacity.
Reliably secure the machine to the lifting gear.
Do not lift the machine with an excavator bucket or forklift.
Evacuate danger zone while lifting, do not stop under suspended loads.
WARNING
Risk of fire and explosion from fuel.
Escaping fuel may catch fire and cause serious burns.
Raise the machine upright.
NOTICE
The fuel cap has an excess and low-pressure valve through which fuel may escape in a
heated state (e.g. in the event of solar radiation).
Item
Designation
1
Fuel cap
1
Summary of Contents for BS Series
Page 50: ......
